Lost GY6 ?

[ctrental]

Bought a buggy with a gy6 that supposedly needed a coil and that was it,,,,,,, so after new coil,regulator,cdi box and engine wiring harness it will now fire but wont do more than idle soon as i hit the throttle easy or hard it dies, still has spark ,I believe it is fuel related although i've cleaned the carb 3 times,flushed the fuel tank am getting fuel to the carb any help would be great :banghead:

[olderthan]

check your float level-set your valves welcome to the group

[joshstep1]

check your float level-set your valves welcome to the group

What's that? Is that the black cylinder that hangs down if you look in the air intake?

[olderthan]

joshstep1 huh?

[joshstep1]

If you look into the carb where the air intake is, there's a black thing that hangs down

[olderthan]

are you talking about the slide

[joshstep1]

Yeah... I guess

[olderthan]

i was confused because they are alum. colored silver esh

[olderthan]

how are you coming on the new buggy

[ctrental]

I adjusted the valves last night and was able to get it running....not right but running...if I feather the gas it will start at high idler (runs great from high idle to full throttle) and able to run it wide open, it's a lot peppier than I thought it would be, but when i come to a stop the clutch is still pulling so when I turn the idle down it bogs out and dies ?

[ctrental]

Yes the Slide is working fine

[ctrental]

Anyone recognize this Brand of Buggy only numbers are on a plate on the floor 150F-04 1200000011

[olderthan]

post more pics of your buggy
you may have a choke problem-if they don't shut off they can cause high idle
pull it measure lenght of the little brass thingy hook to battery for 5 min should get
about 1/4 longer. where the 2 bolts on the housing for carb goes is a small hole into the
carb clean it also

[joshstep1]

how are you coming on the new buggy

Ugh. I don't think it has any compression