58.5 piston kit ring gap?
I orderd a 58.5 high compression kit and measured the ring gap. The top ring has .007 and 2nd has .010 of a inch. I am not sure if I should make it bigger
or leave it alone and take it easy on the motor until it wears in. I dont want to blow it up but I dont want to loose performance by making the rings too loose. I read that .004 per inch of bore is the rule. So 2.3 inches comes out to .009. I dont want to loose the square edge on the ring, or take a chance on chipping or breaking the ring when filing it. Any body have the minimum specs for a 150 piston rings? |
.009" - .010" is good. Just make sure the ring is squared in the bore using the piston appx. 1" below the top deck.
TOM |
Thanks tom for replying back I will double check it and shoot for .009 thanks.
|
All times are GMT -5. The time now is 06:31 AM. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.