BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum

BuggyMasters.Com - An On Line Mini Buggy Forum and Go Kart Forum (http://www.buggymasters.com/forum/index.php)
-   150cc GY6 and Under Engine Tech (http://www.buggymasters.com/forum/forumdisplay.php?f=29)
-   -   Gy6 150 smokes until warm (http://www.buggymasters.com/forum/showthread.php?t=5627)

Traxman 12-01-2015 04:50 PM

Gy6 150 smokes until warm
 
I have a 2014 Trailmaster 150. Last week it started smelling funny so I checked the oil and it was super low. I put some new in there and it smokes pure blue smoke until warm. Did I mess up the rings

OLDKID 12-01-2015 05:14 PM

Only your compression gauge knows for sure , smelled funny - like a metallic smell - overheated ?

Traxman 12-01-2015 06:46 PM

Idk it just smelled funny. I was thinking if the rings would have went out while the oil was low it was leak all the time. After 1-2 minuets the smoke goes away and there is no smell of burning oil.

ckau 12-03-2015 05:00 AM

Quote:

Originally Posted by Traxman (Post 48539)
Idk it just smelled funny. I was thinking if the rings would have went out while the oil was low it was leak all the time. After 1-2 minuets the smoke goes away and there is no smell of burning oil.

You got worn valve guides, Oil seeps into the cylinder from around the valve stem.

Traxman 12-03-2015 08:52 AM

Okay. Now everything comes together. I bought a cheap air filter off amazon and I took it off yesterday and there was dirt all over the inside of the air tube. It barely cranks now so I know the carb needs cleaning and I'm sure the head is gunked up. Thanks for the help

maybe2fast 12-07-2015 12:09 PM

Scored cylinder walls from the dirt too!

Traxman 12-08-2015 11:58 PM

I'm gona slip in a 155cc kit and big valve head while I'm at it. I'm sure I have lost a good bit of compression too cause it's real hard to start.

xlint89 12-09-2015 08:18 PM

Make sure to port match the new head to the intake manifold and exhaust. There is a good amount of performance to be had from doing that. The factory casting is pretty rough normally.

Traxman 12-09-2015 10:41 PM

I'm getting a taida bolt-on 61mm bbk and taida big valve head for Christmas. What kind and size carb would you recommend for that setup. I know for sure my rings are bad cause it's always burning oil and I might as well add 20 cc while Im in the engine that far.

scjeep4.7HO 12-10-2015 08:17 AM

From what I have read/heard the stock carb is fine as long as you rejet it.


All times are GMT -5. The time now is 02:23 PM.

Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.