Basic wiring needed
I have an older Carbide 150, vandals ripped the wiring out and now I have a mess. Can anyone tell me what is the basic wiring needed to make it run? I do not need the lights/instruments etc. I just want the most basic wiring needed to run. I might be able to splice my wiring harness together, I just can't tell what goes where.
thanks |
welcome bigal, a poster on here named 2slicknick has a carbide and may be able to help you.you can private message him or contact him through a post he has on the main screen about protective netting. zman
|
Sent you a pm with the links. Hope that helps. I hate electrical problems and vandals.
|
did you get anything figured out yet? or at least a start?
|
I believe we have the wires back to where they belong, we still do not have a spark. From what I read I am guessing I will need a new CDI and coil
|
Do you have a multimeter? There may be a bad ground wire somewhere. Does it turn over?
Maybe this will help http://www.youtube.com/watch?v=wbHSf...e_gdata_player Check that you have continuity with wires. The ground at the cvt cover commonly not always grounded properly. Check all grounds and fuses. Check continuity in coil wire. |
engine will turn over, checked the wires going to coil, no voltage when cranking. I do not know how to test the cdi unit
|
Hope you figure it out, as I am no one for electrical problems.
|
Go to the american sport works web site and download the 7150 engine manual. It will give you all the information yoy need to check the electrical.
|
All times are GMT -5. The time now is 10:59 PM. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.