Basic wiring needed
 

I have an older Carbide 150, vandals ripped the wiring out and now I have a mess. Can anyone tell me what is the basic wiring needed to make it run? I do not need the lights/instruments etc. I just want the most basic wiring needed to run. I might be able to splice my wiring harness together, I just can't tell what goes where.
thanks

welcome bigal, a poster on here named 2slicknick has a carbide and may be able to help you.you can private message him or contact him through a post he has on the main screen about protective netting. zman

Sent you a pm with the links. Hope that helps. I hate electrical problems and vandals.

did you get anything figured out yet? or at least a start?

I believe we have the wires back to where they belong, we still do not have a spark. From what I read I am guessing I will need a new CDI and coil

Do you have a multimeter? There may be a bad ground wire somewhere. Does it turn over?
Maybe this will help

http://www.youtube.com/watch?v=wbHSf...e_gdata_player

Check that you have continuity with wires.
The ground at the cvt cover commonly not always grounded properly. Check all grounds and fuses.
Check continuity in coil wire.

engine will turn over, checked the wires going to coil, no voltage when cranking. I do not know how to test the cdi unit

Hope you figure it out, as I am no one for electrical problems.

Go to the american sport works web site and download the 7150 engine manual. It will give you all the information yoy need to check the electrical.