helix 150cc transmission
 

motor runs fine but when riding and you give it gas it acts like trans is slipping iv already adjusted the cables that didn't work

so it doesn't want to go any where despite the engine revving?

i have taken off that cover where the belt is and there is oil or grease all over it .yes it will go when given gas but if you really get on it it wont put out

Last part of that post sounds like my wife..

jtown...lol...I heard that...

Anyways, ya there are two seals in there. Ours leaks too. The seals are cheap. We haven't replaced ours just yet. Is the belt actually slick?

Now that is funny after i went back and read ....that last part of my post i think we all get let down sooner or latter.

all it takes is a wedding ring and it's all over

replace your seals & get a new belt likely-my wife of 35 years still does