Lost GY6 ?
 

Bought a buggy with a gy6 that supposedly needed a coil and that was it,,,,,,, so after new coil,regulator,cdi box and engine wiring harness it will now fire but wont do more than idle soon as i hit the throttle easy or hard it dies, still has spark ,I believe it is fuel related although i've cleaned the carb 3 times,flushed the fuel tank am getting fuel to the carb any help would be great :banghead:

check your float level-set your valves welcome to the group

What's that? Is that the black cylinder that hangs down if you look in the air intake?

joshstep1 huh?

If you look into the carb where the air intake is, there's a black thing that hangs down

are you talking about the slide

Yeah... I guess

i was confused because they are alum. colored silver esh

how are you coming on the new buggy

I adjusted the valves last night and was able to get it running....not right but running...if I feather the gas it will start at high idler (runs great from high idle to full throttle) and able to run it wide open, it's a lot peppier than I thought it would be, but when i come to a stop the clutch is still pulling so when I turn the idle down it bogs out and dies ?

Yes the Slide is working fine

Anyone recognize this Brand of Buggy only numbers are on a plate on the floor 150F-04 1200000011

post more pics of your buggy
you may have a choke problem-if they don't shut off they can cause high idle
pull it measure lenght of the little brass thingy hook to battery for 5 min should get
about 1/4 longer. where the 2 bolts on the housing for carb goes is a small hole into the
carb clean it also

Ugh. I don't think it has any compression