"QUOTE" ckau - why did you decide on a right side drivers position?The explaination is on post#18. I'm making everything from one side to the other the same so at a later date when I can afford it I'll switch it over without too much trouble.
Here's some pic's of the header mod's & coolant line mod.I had to beat a piece of 2" tubing into submission to make the collectors!
Tip: when cutting headers try to do the mod near the end so you can detail the inside of the pipe for good flow-also don't cool the pipe with water as that will make the pipe very brittle,let the pipe cool off on it's own.
|