so far ao good
Thanks for the info. Someone else posted on another post too, I ended up pulling the back of the ignition switch barrel off to see what contacts and hence what wires are connected.
There are indeed 3 that need connecting and translated to all except ground and kill switch :-D
The little buggy is pretty quick, and as it snowed here the other day my gf took her for a test drive (I don't fit being 6ft)... The maxtorque clutch is new and makes a lot of noise and heat....i read somewhere you need to run them in? Should they get super hot? And when the buggy was wedged in the snow (or the wheels are under any load when about to move) the clutch doesn't seem to translate the power from the engine? Any ideas or will that get better as I run the clutch in?
Regards and thanks
JB
|