Cool thanks, I have the BD spindles on the front so I guess I should be good there (don't know what offset is??, I'm kinda a newb if you haven't noticed! lol) I think I just figured it out, it says the rim is centered so you just divided the 7" by 2, simple enough. So in order to clear the spindle I have to have enough for the 3.5" on the inboard side. Yeah, I noticed that about them fitting on the rear, I measured my rear hubs and they are in fact 4x110... It confused me at first, they should fix that.
Here are a few pics with the SC shocks up front, much better...
one quick question, in the left pic if you look at the spindle where it attaches to the tie rod ball end, you can see that it is a little bent towards the tire about 1cm... I was letting my friends brother n law drive through our trails and he clipped a tree. I don't want to have to send the spindle back for something simple like this but I would like to unbend it. How would you go about unbending it without messing something up?
Last edited by T3beatz; 11-23-2011 at 08:29 PM.
|