Been keeping that in mind. The rear mount on the carter that adjusts the chain/engine level is a round puck in a metal cup that doesn't fit into the yerf bracket (too wide). I may have to make a set of drop hangars to lower the front ones and make something new for the back. just about ready to weld in the upper shock mounts, once they're in i can set it down and see where the engine needs to go.
Does anyone know if there's a ready-made spacer that fits the stock yerf sprocket? need to move it over about 3/4-in.
Really gotta finish this up so i can get back to the little cart.
Last edited by x-bird; 01-26-2012 at 09:31 AM.
|