I took the wiring harness off, and after some......well.........wiggling and jiggling plus removing the air box, I will be danged if the dadgum thing started great. I had it jacked up with the rear wheels off the ground with the throttle wide open and it ran great. I started doing a little tweaking on the fuel air mixture when i found that the screw was missing but it was running fine. I replaced it and it ran fine for a couple of seconds and then started bogging down and finally it would not start. looks like i am going to have to go over it again. One thing that i am going to try to do is take a large heater hose, and an external air filter and customize it to fit and work better. I think this is one of those macheenZ that will make ghost symptoms as it runs better. I am sure the rear wheels will fit the four bolt pattern, but where will I get a four bolt pattern spacer for the front spindles with only the spindle and uninut.
|