Checking on Light Bulbs Replacement
I bought a couple of the suggested bulbs, with the male spade white wire connector. Before I splice them into the buggy harness/connector, is there anything I should consider to avoid blowing them out? I got the 35 watt bulbs to replace the 15W's in the buggy. I do plan to check out the light switch first, since on a previous test with the engine running, I got voltage at the harness connectors with the switch both on and off. I'm going to repeat that test with a voltmeter instead of the test light.
Any warnings, precautions, concerns, possible problems, etc.?
|