I see you did the turning test with the old spindles on there... how is it with the BD spindles?
Just a suggestion... I had the uneven A-arms and they suck! my turning was just like yours. I asked these guys on here several times what they think the problem is but we could not find a solution.
The next thing I did was to extend the top A-arms, drill new holes in the BD spindes equal to the bottom ones. Cut off the extra metal from the top of the spindles.
I also cut off the old shock mounts made some new ones from some 1x2 square tubing (3/4" ID), I and mounted them so that I could run longer better shocks on the top.
You are gonna want to get a welder if you don't have one! I promise you this...
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
|