Thread
:
swingarm bushings?
View Single Post
#
13
07-10-2012, 12:56 PM
roysheepdog
Contributor
Join Date: Aug 2009
Location: texas
Posts: 402
You could get some flat bar cut it to fit the tube drill the hole and weld the bung on both sides of the flat bar then weld that to the tube.With the tubs being 2x2 (if you trust your welds) the flat bar wont bend if you get it thick enough.
__________________
http://www.youtube.com/watch?v=IUgir...ature=g-t=2668
FABRICATION ITS HARDER THAN YOU THINK
roysheepdog
View Public Profile
Send a private message to roysheepdog
Find all posts by roysheepdog