What do you mean about the 4x4 fitting the spindles? There is no heims kit, it is a modification you do to the a-arms on the front that makes them stronger, adjustable, and much better than the stock ball joints. You buy the Heims and weld in bungs, cut off the old tabs where the ball joints mount to, drill holes weld in the bungs and then screw in the Heims. Bolt on the stock spindles or the BD spindles, and done. The 4x4 hubs should fit as long as you have the correct size bearings installed in them (5/8" ID is the stock size).
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
|