03-07-2013, 11:01 AM
|
Contributor
|
|
Join Date: Nov 2012
Location: Ringgold, GA
Posts: 383
|
|
im talking about the 17mm nut on the outside of the clutch bell.
Answer me this. Our pulley has that sleeve that the torque spring rests against. The one we take off to adjust the groove. I have a slightly bigger sleeve on the end of my main spring also. Does this sleeve go against the clutch itself, or does it fit over the sleeve on the pulley? I may have mine on backwards not allowing my pulley to open fully.
|