now i found some cold rolled steal that would all most fit inside the swing arm.
so i cut the swing arm & ground down the steal stock to fit in the swing arm.
I decided to make the extension 10"
welded them in and put the axle in back in back in fliped around so the sprocket is on the left side.
checked the area out with the motor sitting there
now if i have some time this weekend I can get the motor/cross mounts cut and welded in
2013-06-15 22.22.55.jpg
2013-06-16 00.54.38.jpg
2013-06-16 11.05.06.jpg
2013-06-16 13.45.00.jpg
2013-06-16 16.00.49.jpg
2013-06-16 16.01.20.jpg
2013-06-16 13.54.38.jpg