My Setup, still not getting enough torque
ASW Carbide 150cc
Intake
126 main jet
38 pilot jet
Dr. Pulley Variator
12g sliders
1500 rpm Yellow Clutch Spring
Performance CDI (adjustable)
Performance Coil
Iridium Plug
Exhaust slightly drilled out.
So today, I put a mix of three 12g sliders and three 10g sliders, alternating them. I didn't see an improvement. I'll go to all 10g sliders tomorrow.
Basically, I'm looking to get this thing spinning it's wheels from a stand still. Speed isn't so important because most of the riding we do is in forest or sand.
I'm wondering if anyone else has this setup and is getting better torque.
The only thing I have left to install are the little yellow clutch springs for the shoes. Will they make a big difference?
Last edited by Danp; 08-29-2013 at 09:33 PM.
|