Switch is fine.
Verified key switch is fine.
The switch is activated and the clicking is coming from the CM6321 relay when the key is turned.
I have the following CDI Connector: AC, 6-pin (4+2) male plug made by TOPEMAI and part number CPKL0042. It has an LED on the side of it but I don’t know if it should be lit or not.
Also on there is a BH-Motor part number ATVCDIkit250cc ignition coil.
When I short across its polls the engine turns over fine. I don’t have fuel to it yet at this point in the build.
The relay as stated before clicks but I don’t think power is getting to the CDI or ignition coil.
Could that relay be bad or underpowered?
Also I’ve checked my grounds and they are ok.
Any thoughts?
|