So what your basically saying is that all I have to do is make the very tip of the exhaust bigger (to 1 1/4'')? I have access to a welder, hack saw and the wooden dowels. What I'm asking is couldn't I just use a step drill to make the exhaust hole 1 1/4'' after cutting the tip off? I was under the impression I'd have to pull all the fiberglass packing out of the muffler.
I don't have a hole saw but I do have a step drill bit that goes to 1 1/4''.
Last edited by Beefcake; 08-18-2010 at 01:30 AM.
|