Xlint...i did check for alteration done to hub,, but nothing was found ..i can try the ice thing...but fill cooler full of ice and water and let water run across axle and it will drain back into cooler and also heat up hub keeping a steady pressure on it....if not I will cut.i have a 4 inch long 2 1/4"OD and 1 3/8"ID STEEL SLEEVE that will slide into place and weld..i debating on one end of double pinning to later remove axle. Dont know ohh and then the point on axle that has less shear load...
Thank u for all ur ideas
|