View Single Post
  #131  
Old 08-28-2013, 09:58 PM
Masteryota's Avatar
Masteryota Masteryota is offline
Senior Member
 

Join Date: Dec 2012
Location: North Florida
Posts: 1,155
Default

Quote:
Originally Posted by x-bird View Post
going with 1" keyed, and taking the 50 sprockets down is probably your best option. watch out with the lower grade steel pre-keyed shafts- they usually have a bow in them from the key cut. on the smaller sprocket sizes (i think, but not sure -- it's right around 19T and under) you will also have to shorten the teeth and recreate teh tip angle on ALL sides of the tooth. a file works fine for adding the inside angle back after taking them down. A lathe or mill is definitely the way to go, but i haven't noticed any unusual wear yet.
Yeah, I was actually going to order it from BMI. The axle I just installed came to me in great condition, and I am rather impressed for the cost. They have some shorter lengths available, too. Too bad I need to order so much from surplus supply, the shipping costs between the two are going to kill me, lol.
__________________
ASE Master and Toyota Master Diagnostic Certified
Buggy Building Trainee

'04 Dazon Raider 150 'modded'