Well i purchased 2 of them new in late,09.by the end of 3 months had to replace. both fuel caps,front spindle assemblys,on both,upper ball joints pounded out bad desighn there putting al the load on the top ball joint,all the steering link ends there cheap,axle bearings x 3,brake calipers, brake pads every summer, coil connectors .water in controll box,cheap chain stretched real bad,main wire conetion harness shorted out were goes into control box,had no water proofin any were,the 1 kart was driven by a 10 year old an hers had same troubls as mine so its not the .rider.now 527 i nedd another caliper the brak pads inside on the piston side falls out when the pad gets low,thenthe cup, hits the rotor ,now they dont makethe calipers no more they changed the esighn ,of course more$$$$$$$$$,if i had to do it again NO,NO, id buy a honda rapture or a 4 wheeler,
