That tire/rim setup doesn't fit the stock bolt pattern. For the rear you need 4x110mm rims (the stock ones are fine) You will just need to find some good tires So you can go here... this is a good all around tire for the rear and this place ships for free over 99 bucks http://www.rockymountainatvmc.com/p/...-Sand-ATV-Tire
If you have a cam and do a head swap, 10g rollers would be overkill, I'd go with sliders, maybe 12-13g like I was saying, they still give you the low you need but will get you higher variation than the rollers will. So you will have the grunt and the extra speed also
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
Last edited by T3beatz; 06-27-2012 at 09:56 PM.
|