View Single Post
  #78  
Old 05-27-2013, 12:36 PM
Masteryota's Avatar
Masteryota Masteryota is offline
Senior Member
 

Join Date: Dec 2012
Location: North Florida
Posts: 1,155
Default

I finally got the front end completed(I hope), and here is a pic of the final tie rod set up wih the centered rack design. I know it isn't perfect and it does have some bump steer, but I don't think its as much as stock. I do wish to incorporate some ackerman into the spindles at some point. In hind sight, I should have used the 8" rack but it would have cost me a lot of turning radius versus the 11" unit.

I began to mock up the engine into the swingarm yesterday, and started making mods, but nothing significant yet.

Today I began my engine work, since I am like the only person working today.....
So far it doesn't look too bad, I'll brush the cylinder and see how it looks, and try to replace the cracked case half today. The upgraded clutch springs should arrive tomorrow, and maybe have the engine ready for the piston kit by the weekend.
Attached Images
File Type: jpg 20130526_232032.jpg (90.0 KB, 34 views)
File Type: jpg 20130526_231931.jpg (82.6 KB, 27 views)
__________________
ASE Master and Toyota Master Diagnostic Certified
Buggy Building Trainee

'04 Dazon Raider 150 'modded'
Reply With Quote