DN150 electrical fix need help
I got the kart in april ,it would not fire. I replaced ignition key switch after fixing wires that melted in front harness.then replaced the rectifier, CDI, Magneto / stator, and master cylinder
took reading from all with DMM
when all was assembled and tested good it had spark fir about 45 seconds but the volts tested out the back of cdi going to coil visibly went from 34vac to 1.3 volts
I still don't know if my brake pedal needs depressed as I am getting right numbers at key cranking i think from all but trigger wire
sometimes it does not measure on my DMM
ANY IDEAS?
stator-34vac @ crank
trigger-.1 @ crank
It keeps blowing cdi
if I put new one one it has good blue spark for about 10 seconds
|