View Single Post
  #68  
Old 04-21-2013, 06:38 PM
Masteryota's Avatar
Masteryota Masteryota is offline
Senior Member
 

Join Date: Dec 2012
Location: North Florida
Posts: 1,155
Default

Got part of my front end mocked up/partially finished today. First broken weld today as well, was trying to use some plated 1/4" plate cut from a motorcycle hitch bracket, need less to say, no penetration and its alot softer than I had imagined. Cut new ones from regular 1/4" plate, and oh so much stronger. Bulkhead bolted down with oversized grade 8 bolts(3/8" up top and 1/2" for the sides). I know I said I was going with heims up front, but with the time constraint and budget dwindling, I cleaned up the bushings and will use them for now, although I am considering using something different than bolts running through them. Anyone know the hardness of 1/2" round stock?? I am betting it isn't even close to grade 8.

Wanted to get a wheel on the front, but didn't have enough bearing grease to install the hubs. Oh well, there's always next weekend.

I do have one other question. I opted for the Latest Rage brand 11" replacement steering rack, and it has heims for the inner tie rods. They want me to use their outers @ $28/ea. I am thinking of chopping the stock inner joint off the sleeve, and welding a clevis on the end and popping a heim on the spindle end. Would it be a safe idea to make my own clevis, or outsource one? It would likely be 3/16" steel if I make it myself, and would it be beneficial to opt for a lower grade bolt on the clevis to help not destroy the inner heim and rack?
Attached Images
File Type: jpg 20130421_190802.jpg (92.2 KB, 33 views)
File Type: jpg 20130421_190748.jpg (84.0 KB, 34 views)
File Type: jpg 20130421_190725.jpg (92.2 KB, 40 views)
File Type: jpg 20130421_155907.jpg (97.2 KB, 38 views)
__________________
ASE Master and Toyota Master Diagnostic Certified
Buggy Building Trainee

'04 Dazon Raider 150 'modded'
Reply With Quote