Hammerhead, Kandi and Roketa all had that buggy design.But all 3 used slightly different specs for their parts. Most common parts will fit but struts are going to be different and some of the engines will be different. In the beginning Kandi who also supplied Roketa were known for copying others designs until taken to the world court by Hammerhead, so they had to make small changes to get around the copy right laws. The main thing to look at is the engine. Does it have a 2 bolt or 4 bolt valve cover and with the valve cover off measure diagonally between two studs which hold the cylinder and head center to center. It should be 3" center to center. If they are 3 1/8' center to center you will have a problem with engine parts. There are a ton of mods to get more power out of that engine, it depends on your budget. Being your new to the buggies all parts are not created equal for you will get what you pay fore. You can get back to me with those measurements and either call me or e-mail me and I can let you know the best route within your budget to get you the best power gain for your dollar. 662-301-1563
tom@sycpowersports.com