Okay, I got the angle steel secure. I Did about 5 one inch fills on each underside of the angle steel ( making 10 fills per angle steel) plus the 4 surface welds for each angle steel. It should be good to go.
Now to put the motor mount in.
Here is a professionally drafted blue print
of what I will be doing today and tomorrow.
I plan on putting the front to rear tubing stacked on the side to side tubing for additional clearance.
I think with the 15 inches between square tubing, the height of motor mount, and the depth of the hangers I should have plenty of clearance for sprocket, disk brake, and jack shaft.