Quote:
Originally Posted by toomanytoys2
2Slick.
I really hate to criticize anyone's work  , but from the pictures, it doesn't look like you are getting good penetration into the round tubing. If that is the case, you might try and grind down the welds and give it another shot. If I am wrong I apologize profusely  . By far I am not an expert welder, I just want to make sure that your project goes as planned for you.
As far as the axle, It has a little surface rust on it so I intend to clean it up and post a pic of it. Hopefully today, but the wife said that I had to clean the garage today. Gotta keep the wife happy to keep working on the toys.  |
Oh you were correct. It was not good penetration. I did grind those down and hit it again.
Great I look forward to that - thanks.
Keeping the wives happy is a full time job that eventually leads to our own happiness.