View Single Post
  #13  
Old 03-31-2011, 10:52 PM
schmidtc194 schmidtc194 is offline
Lurker
 

Join Date: Mar 2011
Location: Mohave Valley, AZ
Posts: 10
Default

Tom:
I did a cmpression check and it was less than 30 psi, also had pressure coming out of vent on head. I took motor apart and the piston was hammered. It had scrapes on top along side. Rings were shot. The cylinder has surface scratches but no deep grooves. Should I replace cylinder? What about valves, they appear ok but I don't really know what to look for. It is the "P" motor and from what I read it has larger valves, do you know where I can get new valves? Thanks for all your help!
Reply With Quote