I've been fussing with it for the past couple days... it's a pain in the but, just can't get that outside wheel to turn less then the inside one and this is with everything lined up as you guys stated. The only other thing I can think of is the rack being off or something. I don't want to cut and re-weld anything (I'm a welding noob) I bought one of the 90Amp harborfreight MIG welders with the flux core wire to learn with and work on the buggies I have. I've been able to make a few quick welds here and there but they are not so pretty yet.
I have some new shocks from Surplus center coming Tues for the front, I'll check everything then, I have to flip the bottom A arms over so that the 12 and 3/4" shocks will fit... I hope they go in with little problems! I have the stock ones from the back that were replaced with some better oil filled ATV ones that are 13-14". I'll test fit them today to see if I'll have to do any major work.
Last edited by T3beatz; 11-20-2011 at 09:59 AM.
|