Today's front end session results. Front view ---Still have to move it inward up top (need to get the original quad A-arm frame piece vertical.)
Side view ---It needs rotated a bit more counter clockwise within the sunl frame to take a couple degrees of added caster out.
All the tubes were ground over and over to get to this point. Probably 3-4 more grinding/fitting sessions to go.
If you have an air disc grinder that you don't use in favor of a 4 1/2 in. electric angle grinder, here's the best $12.00 you can spend -- if you've pack-ratted your old discs. I've always taken my bigger grinder discs and successively cut them down for re-use. My compressor though is a very loud oil-less so i use it very little for fab work. This just saved me a bunch of money since i have piles of 5 in discs with worn out edges. Sears hardware "4 1/2 angle grinder conversion kit" comes with 2 50-grit discs which didn't last too long as they were noticeably thinner than all of my old ones.
