Thread
:
A little bigger project
View Single Post
#
11
02-03-2014, 05:33 PM
Masteryota
Senior Member
Join Date: Dec 2012
Location: North Florida
Posts: 1,155
Been a while since I updated, mainly due to some house issues and lots of small things being nailed down to move forward in the swap. De-powered the rack and installed, only to find the rack mounts were not parallel-FIXED. Stripped the old ECM wiring out of the car, along with the remaining SRS wiring and impact sensors. Stripped all unnecessary engine wiring and depinned the wires from the ECM connectors, both harnesses tagged for mating up. Made some mods tot he engine while it was out, rerouted the 'steam vent' port to the top of the water pump(sorry, no pic) and tapped and plugged the heater ports on the side thermostat housing(again, sorry, no pics) to delete the heat ports and clean up the engine bay a bit.
__________________
ASE Master and Toyota Master Diagnostic Certified
Buggy Building Trainee
'04 Dazon Raider 150 'modded'
Masteryota
View Public Profile
Send a private message to Masteryota
Find all posts by Masteryota