Quote:
Originally Posted by plee911
No worries Beef I figured you had been busy.
Remind me what the size was for the big valves so I can check.
Plan to do a general port and polish and lap the valves when I get the kit ordered.
Not gonna go crazy just clean it up and do what I can to polish the exhaust side
|
Without a flow bench I suggest just cleaning up the casting flaws and opening the ports to the same size as gaskets. When opening them up just blend it in about an inch inside the port. Leave the intake runner a bit rough but the exhaust can be as close to mirror polished as you want to spend the time on.