these are the bearings that mine came with http://www.*************/item/Wheel-B...ID-300171-5885
Out the box they have more slop then the ones I posted earlier. The problem is when I tighten down the axle bolt onto the hub it kinda squeezes it a little, and that coupled with the abuse from the trails they start to loosen up more. I think if I put a spacer in the center of the hub in between the bearings then tighten it down it would keep the lateral pressure off them making them last a lot longer.
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
|