If you could I would just sell the Ball joints, I'm sure you could find someone who will take them off your hands.
Doing my heims it only cost me about $60 bucks for everything and it's a lot better than the ball joints.
You don't even have to buy new top arms, just grab some 1" ID tubing cut the existing top A-arms and slide the tubing over them to extend to the proper length.
here are a couple pics of what I had to do.
You can see how I slipped the tubing over the A-arm, and cut off the left over part of the spindle, and the shock mounts I had to fab up. Also I used the same 1x2 tubing to stand my rack n pinion off for better steering geometry.
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
|