Dan, I know this is almost 5 years ago, but any chance you are still around? Believe it or not, i just picked up the exact same cart (in worse starting shape). Finished stripping it down, mine also minus the engine and CVT, so same rear end config as yours, just the FNR gearbox. I have a question. On my FNR, the input shaft just pulled right out. Was planning on taking it apart anyway to check wear and clean out the old fluid, but obviously this made it mandatory as the internal gears just dropped off. Wear was pretty much zero, everything fits up good. Nobody lubes it in a long time. But I cannot figure out how that input shaft is kept in place. Was thinking I would need something rigged up externally to hold it in. Did you ever have yours apart or run into this issue?
|