[RDomke]

Took your advice, installed a cross brace mounted the Polaris hydraulic brake , but did keep the FL250 hand brake. ( In case my main brake install is not reliable.)
Tomorrow I will center the brake disk flange and weld it to the shaft. I will have to tack, tack, then check for wobble and concentric alienment adjust as necessary and finish weld.


To get the engine and mounting plate off in one piece (because its all aliened) I had to comealong it to the cross bar in my cage roof then let it down to a rolling table. Darn thing with clutch and plate got heavy.

I'm looking forward to getting it together on the ground, and building the cage and spring supports.

Enjoy