Mine was the same way with the no choke needed. Was a real beotch to idle after starting on its own. I had to hold the throttle until it warmed up, unless it was a cold day. Then it would idle fine with no choke. Once the engine was warmed up, it held idle just fine.
Look at the throttle slide cut out number, does it match up? Mine didn't
What size needle/seat is in it?
Did you check float height adjustment?
__________________
My Yerban assault vehicle: 2.2mm stroker crank, 62mm Nikasil cyl, Taida large vavle head, American made valve springs, ported intake manifold, TM 28mm carb, stock CDI, Bando coil, TK exhaust, stock CVT except for the 14g sliders, 13/40 internal gears, 16T drive, 31T axle sprocket, 22" rear tires, and ONE BIG POTATO CANNON mounted on top..........
Last edited by xlint89; 01-21-2015 at 10:54 PM.
|