View Single Post
  #23  
Old 10-31-2017, 02:29 PM
JERSEYDEVIL's Avatar
JERSEYDEVIL JERSEYDEVIL is offline
Supporting Vendor
 

Join Date: Feb 2011
Location: port charlotte fl
Posts: 831
Default


well i had to go and do it.......i had to take a good chunk of a week and clean my shop!
i just couldnt take it any more, but it was well worth it. it's amazing the things you find!
started up again and knocked out a few things.
1st, test fit a motor and had to make an alteration to one of the legs. the plastic shroud was hitting on the right side. other than that everything seems to eyeball up pretty well.
2nd got the motor built about 85%, basically just need to install the clutching and build an exhaust for it.
3rd , cut and ground some more stuff off of the frame like the keyswitch box and grab bar on the dash and cleaned up the lines of the roof.

my camera took a dump so i had to demote one of my others to "shop camera", and use my phone , so i have other pics i'll have to post later.
Attached Images
File Type: jpg DSCF3828.jpg (96.3 KB, 14 views)
File Type: jpg DSCF3829.jpg (88.7 KB, 9 views)
File Type: jpg DSCF3830.jpg (90.7 KB, 8 views)
File Type: jpg DSCF3831.jpg (87.0 KB, 13 views)
__________________

"LUCIFER" JOYNER JD400,
CROSSHAMMER 250R,
YERF GX150,
CROSSFIRE MBX150,
BMS 800V-TWIN
'16 RZR 900s ,
'17 ACE 900XC,
'99KX250,
'94 KDX200,
'18 SSR SR170TX

Reply With Quote