[Immokalee]

I bought the Slider Weight 18x14x12.5G, and a 1500 rpm main spring for my 150cc Hammerhead and installed them today. I was sorely dissapointed when my wife took off in hers (same buggy) and left me in the dust on the take off. I could pretty much tell when I backed it off the trailer that I was going to get smoked, it bogged so bad coming out of the hole that I was ready to load it on the trailer and drag it home wih my tail between my legs. I plan on a ride this weekend and I don't want to be the one holding up the party. I followed the KNM you tube video and everything seemed pretty easy.

I weighed the stock rollers, which were 14g, the sliders I purchasd were 12.5g. My stock rollers are 14g. I marked the nut on the clutch when I took it off to install the main spring but I went passed that mark by about an 1/8" when I torqued it back down. Could this be part of the problem?