Got it all installed and it fired right up. Still need to adjust tension on the throttle cable, and hopefully find some flexible couplers that are a little less thick. Hammerhead racing exhaust sounds bad ass. Not sure if the throttle cable is in the correct (out of the three) bracket, but seems to run good.  Thanks again to all the good souls that lend wisdom and advise!
__________________
2013 Trailmaster XRX 150 Type 86 stroker
Taida 4V head with 23/22mm valves, forged 4V piston,Taida 62mm jug,forged Taida 8200 KDU stroker crank, Koso high-flow oil pump, Taida case half w/ oil cooler ports, Setrab oil cooler,TrailTec Vapor, Mikuni VM26-606, aluminum 30mm intake, Uni filter, aluminum stack, Hammerhead racing exhaust, MotoRio adjustable CDI/HO Coil, Iridium plug, Full Dr Pulley CVT kit w/ 16g sliders, JD's Mikuni slide kit
2014 Kandi 90B
|