View Single Post
  #43  
Old 03-03-2013, 06:45 PM
Masteryota's Avatar
Masteryota Masteryota is offline
Senior Member
 

Join Date: Dec 2012
Location: North Florida
Posts: 1,155
Default Days 3 and 4

OK, so got the the top bar all squared away and braced in. Added a piece of 1/4" plate across the front section of the main frame, as I see a lot of Yerf pics with the welds cracked right there. I finally got my front spindles in Saturday, and installed them today, I plan on running a 20x7x8 up front, but left enough spacing in case I want to run something wider, if my calculations are correct, I should be able to squeeze a 10" wide tire up there without spacers, just threw a coat of flat black rustoleum on there for protection.

Managed to get one of the cage bars tacked in today, just in time for the temp to drop into the 30's. Moved the bar 2" outwards on the top, and tried to keep the bar somewhat close to perfectly vertical, and added roughly 5" to the front pipe to make it fit. Good thing I decided to scrap the rear loop thing off the back, cause thats where the extra came from, lol.
Attached Images
File Type: jpg 20130303_183716.jpg (96.0 KB, 39 views)
File Type: jpg 20130303_183652.jpg (90.4 KB, 34 views)
File Type: jpg 20130303_183611.jpg (87.9 KB, 40 views)
File Type: jpg 20130303_183553.jpg (90.0 KB, 36 views)
File Type: jpg 20130303_183547.jpg (92.1 KB, 36 views)
__________________
ASE Master and Toyota Master Diagnostic Certified
Buggy Building Trainee

'04 Dazon Raider 150 'modded'
Reply With Quote