[plee911]

You can do the wires yourself. You probably wont find much that is plug and play. I had to redo all of my wires and switches on mine from scratch.

Buggy depot makes a good harness but it was not what i wanted so i built my own.

Dont go with less than 14 ga wire if your going to do it yourself. You wont regret it. Use 6ga or 8 GA for your primary battery wires. Also if doing it yourself add a couple of extra grounds to the frame. 1 up front one middle and ground engine to swing arm and swing arm to frame. The grounds get dirty and lose connection so by adding extras you will prevent a lot of problems with losing a ground. the swing arm will not ground good to the main frame so adding one here is critical. One from engine direct to frame is a good call as well.

Mine had a lot of electrical gremlins but the extra grounds and the heavier wire all around made all the difference in the world