[danthony]

Hello everyone, i have a question that seems to be stumping me...i recently got a 2008 hammerhead gt 150 with the gy6 motor..it had been setting up for 5 years and it was completely out of the weather...so here is what i done,
1. New petcock diaphram on gas tank.
2. New 26mm manifold intake
3. New 26mm carb with 125 main jet
4. New high flo air intake
5. New fuel lines, fuel filter, and vaccum lines
6. New orange hot ignition coil
7. New yellow cdi with adjustable curve
8. New variator sliders (11 grain)
9. New 1500 rpm main clutch spring
10. New clutch

so this thing busts right off and idles like a dream, and runs like a champ too, until you run it at wide open throttle for about 10-12 secconds or so..then it stalls out like my carb bowel ran out of gas...i can let off the gas and in about 4-7 secs its good to go again..i need some help fellers!!!!!! It runs to good from low end to right before it stalls out, so i'm thinking it a fuel problem..possible running out of gas, but i dont know how to get more gas to my carb???? Any ideas???