Quote:
Originally Posted by OLDKID
Fibber , fibber, fibber, ( In regards to the only original Yerf frame bits )
That's a front top hoop of a 3203 cage if I ever did see one .
Always loved the look of those cages .  |
Nope, cutting off the flattened bolt-on mounting sections lowered the front hoop too much. I had a new one bent up at my buddy's shop when I put the new front end tubing structure on it. New one is a bit wider up top with the tubes running parallel. Old one was a little narrower up top with the tubes tapering inwards from bottom to top.
you are close though, I did keep the rear hoop.
3:13 in this vid
http://www.youtube.com/watch?v=LyfpcBigXXg shows the initial remains of the yerf frame. I've since pretty much eliminated all of the old rear rack structure along with moving (several times) the vertical tubes below the rear hoop.