Status update
So the weather here has not been my friend. Sunny and warm on days I have to work 20 MPH wind, rain and Snow on my days off. (Man I need a garage)
Here is the current status
Verified I have the 39 tooth sprocket
Have the battery picked out but not picked up yet
Still waiting for front tires to be delivered
Parts that have come in
new master cylinder
new tubes for front and rear
new ignition switch
new light switch
new horn button
new kill switch
new turn signal switch
and
200 ft or 14 ga wire that I have been waiting on
If the weather decides to play nice this weekend this is the plan
1 Now that I have the last of the wire I can finally get all of the wire harness redone.
2 get all the new switches and ignition installed
3 get the master cylinder installed and bleed the brakes (this sounds like a fun chore)
4 pull back tires and get tubes installed
5 Pull and clean carb, pet cock and tank (It has sat for a few weeks cause of work and weather and now doesn't want to start and I noticed that the fuel filter wasn't staying full so thinking I have a flow problem at the tank.) may go to 1/4 lines with good clamps instead of the 3/16 stuff I have on there too.
Still have a lot to do and a lot of parts to get but with only 1 day off per week on 12 to 16 hour shifts its a slow process
|