I got in the replacement starter clutch. All went well until I got to the flywheel. After going to AutoZone twice to get the correct gear puller (first one was too small), I finally got it off. Apparently, it had never been removed and was not happy about separating from the shaft. When it did finally release, there were 2 very distinct areas where the puller flattened out the flywheel. I did get the rest of the parts off and have replaced the starter clutch. I did check the old one and do not see anything wrong with it, but I changed it anyway. I have begun to reassemble the cart, but now have to wait on a replacement flywheel. The journey continues...
|